www.daewoopower.bg
6
6
Cone nozzle
:HOGLQJVKULQNVOHHYLQJKHDW
concentrated over small
area )
Fish tail surface nozzle
Drying, thawing (heat spread over wider area )
Scraper
Stripping paint and varnish
Make sure that the tool is switched off and the nozzle has cooled down.
Falling down nozzle can set an object on fire. Nozzles must be mounted firmly and secure on the
unit.
Touching a hot nozzle can lead to serious burns .Before attaching or replacing a nozzle, allow the
unit to cool down completely or use a suitable tool.
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only
original nozzles according to the table that are suitable for your unit.
8
INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.
Use only one hand to hold the tool, do not place your other hand over the air vents
Prior to operation :
Mount the correct accessory for the application.
Set the desired air temperature.
8.1
Switching on and off
To switch the tool on, set the on/off switch to position
ĉ
/
Ċ
. Some smoke may be emitted after
switching on; this does not indicate a problem.
To switch the tool off,
set the on/off switch to position
ĉ
, and let it run for a few minutes
. Then set
WKHRQRIIVZLWFKWRSRVLWLRQ/HWWKHW
ool cool down before moving or storing it.
8.2
Temperature setting.
Turn ON/OFF switch to
ĉ
/
Ċ
, depending on temperature you need. The heat gun will start to buzz.
8.3
Stripping paint
Mount an appropriate accessory.
Set a high air temperature.
Switch the tool on.
Direct the hot air onto the paint to be removed.
:KHQWKHSDLQWVRIWHQVVFUDSHWKHSDLQWDZD\XVLQJDKDQGVFUDSHU
Do not strip metal window frames, as the heat may be conducted onto the glass and
crack it. When stripping other window frames, use the glass protection nozzle.
Summary of Contents for DAHG2000
Page 10: ...www daewoopower bg...
