Vehicle Systems
Disassembly & Assembly
Steering Wheel
Remove And Install Steering Wheel
1.
Remove cap (1) from the steering wheel.
2.
Remove nut (3) and cup (2) from the steering
wheel.
3.
Use a suitable puller to remove the steering
wheel. Later models will have threaded holes in
the steering wheel to install a puller.
NOTE:
The following steps are for installation of the
steering wheel.
4.
Put the steering wheel in position on the shaft.
Install cup (2) and nut (3). Tighten the nut to a
torque of 80
L
7 N
I
m (60
L
5 lb
I
ft).
5.
Install cap (1) on the steering wheel.
Steering Column
Remove Steering Column
Start By:
a.
remove steering wheel.
1.
Remove bolts (1) and front cover (2).
2.
Remove bolts (3), and top cover and instrument
group assembly (4) from the support assembly.
3.
Put identification marks on all hoses and wires for
installation purposes. Disconnect four connectors
(6) from the light switch (if equipped). Disconnect
two wiring harness connectors (7). Remove the
cover and instrument group assembly from the
steering column.
56
IDCD309S
IDCD312S
1
2
3
4
1
2
3