Fitting the electric blanket
1.
Place the blanket on the mattress, leaving room for the pillow and with the mains lead
at the pillow end.
2.
Pass the middle tie tape under the mattress and through the middle loop on the
opposite side.
(1)
3.
Pass the end tape under the corresponding corner of the mattress, through the end loop
and down under the other bottom corner and then through the bottom side loop and
tie firmly.(2)
4.
Repeat procedure for the tie tape at the top end.(3)
5.
The blanket should now be firmly tied to the bed.
Operation and controls
This blanket is only to be used with the controller supplied with the
appliance.
The controller has raised markings to allow for easy temperature
adjustment in the dark.
The settings are:
O
OFF
1
Low Heat
2
Medium Heat
3
Pre-Heat
1
2
3
