Cylinder/Piston
●
Insert the piston ring into the inside of the
cylinder, and check the piston ring clearance.
NOTE
Service limit: Top/second 0.50mm (0.020in)
Oil (side rail) 1.10mm (0.040in)
●
Measure the piston outer diameter at a point
10mm from the piston bottom in the direction of
90
。
to the piston pin
Service limit: 55.82mm (2.198in)
●
Measure the inner diameter of the piston pin hole.
Service limit: 15.038mm (0.5920in)
●
Measure the outer diameter of the piston pin.
Service limit: 14.960mm (0.5890in)
●
Check the clearance between the piston and piston pin.
Service limit: 0.020mm (0.00008in)
●
Measure the inner diameter of the connecting rod
small end.
Service limit: 15.060mm (0.5930in)
●
Check the clearance between inner diameter of
the connecting rod small end and the piston pin.
Service limit: 0.040mm (0.0020in)
10-4
Use the piston head to insert the piston ring so
that the piston can be level.
Feeler gauge
Summary of Contents for NS125III - SERVICE
