11-5 Crankshaft Inspection
Use a thickness gauge to measure left and right
clearance of connecting rod big end.
Service limit: 0.6 mm
Measure the clearance of the big end at the vertical
directions.
Service limit: 0.05 mm
Place the crankshaft on a V-block, measure run-out
of the crankshaft.
Service limit: 0.10 mm
Check crankshaft bearing
Use hand to crank the bearing to see it moves
freely, smoothly and noiseless.
Check the inner ring to see it links firmly on the
bearing.
If any roughness, noise and loose linkage are
detected, replace the bearing with new one.
Caution
The bearing shall be replaced in pair.
Special tool: outer bearing puller
Check balance shaft bearing
90 mm
Crank bearing
Measure point for the crank big
end of the connecting rod.
60 mm
Summary of Contents for ET300 - SERVICE
Page 1: ...1 ET 300 Service Manual ...
Page 142: ...REAR BRAKE ...
Page 160: ......
Page 161: ...17 8 Wiring Diagram ...