Daedong 3C093, Operator'S Manual

Page: 38 / 51

38 DIESEL ENGINE
POSSIBLE CAUSE
! ! ! ! !
Check and clean injection nozzles, being careful not to damage the orifice.
! !
! !
!
Replace injection nozzle(s) if not working properly after cleaning.
! ! ! ! !
Check valves for leakage – grind valves to correct.
! !
! ! !
Check for bad valves, piston wear, ring damage or wear, or liner wear.
Have parts replaced.
! ! ! ! !
Check and service fuel system
! !
! ! !
Check for and repair leaks. Fill to correct oil level.
! ! ! ! !
Check for clogged oil filter and replace.
! ! ! ! !
Check oil pump and lubrication system.
! !
! !
!
Check to see if engine bearing clearance is within specifications.
! ! ! ! !
Follow oil and filter service instructions to prevent future occurrences.
! !
! ! !
Proper injection timing (crank angle before top dead center)
- Model 3CO93: 22
o
- Model 3CO93G: 24
o
- Models 3A139, 3A165, 4A200, 4A220: 18 o
- Models TD1300, TD1400, TD1700: 20
o
- Model 4A200T, 4A220T: 12
o
! !
! !
!
Check and adjust valve clearance when the engine is cold.
- Models 3CO93, 3CO93G, TD1300, TD1400, TD1700: intake 0.1mm, exhaust 0.1mm
- Models 3A139, 3A165, 4A200, 4A220: intake 0.25 mm, exhaust 0.30 mm
- Model 4A200T, 4A220T: intake 0.15mm, exhaust 0.15 mm
! ! ! ! !
Clean or replace the element every 100hours of operation.
! !
! ! !
Check the injection pump and valve assembly. Replace as required.
! ! ! ! !
NOTE: Poor quality fuel or improper fuels will accelerate injection pump wear.
! ! ! ! !
Adjust to proper pressure 140~150 kgf/cm 2 (13.73~14.7Mpa, 1991~2133psi)
Clogged or faulty fuel injector
Low compression
Insufficient fuel flow
Seizure of moving parts
Incorrect fuel injection timing
Improper valve clearance
Dirty air cleaner
Fuel injection pump wear
PROBLEM: LOW ENGINE POWER OUTPUT
CORRECTIVE ACTIONS