Dacor Wall Ovens, Installation Instructions Manual

Page: 8 / 12

Page 6 Page 7
WARNINGS:
1. Do not ground the appliance to a gas supply pipe or hot water pipe.
2. Do not turn on power to the appliance until the oven is permanently grounded.
3. Grounded cold water pipe must have metal continuity to electrically ground and must not be
interrupted by insulating materials. Any insulating materials must be jumped as shown in Figure
10 below with a length of No. 4 copper wire securely clamped to bare metal at both ends.
Conduit from
appliance
Cable from
power supply
Wire nut
(4 places)
Junction
box
RED
RED
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
Separate No. 10 (minimum)
copper grounding wire
Clamp must be
tight on pipe
No. 4
copper wire
Metal
water pipe
Clamps
Bare metal
Meter
Figure 10:
Connecting the appliance ground to a grounded junction box wire or cold water pipe.
STEP 7
Electrical Connection (Cont.)
STEP 8
Mounting the Oven
Lift the wall oven up to the cabinet cutout, using the upper edge of the cavity opening and the bottom of the oven case side as gripping points.
Use extreme caution when lifting the appliance as it is heavy. Be certain to take all necessary safety precautions.
Resting the oven on the cabinet-mounting platform, slide the oven into the recessed area until the rear edge of the oven frame is flush with
the cabinet face and the oven is centered within the cutout. Ensure that the electrical conduit slides through the opening in the cabinet platform
or coils above the oven chassis as the oven is slid into place. The cable must be placed into the recessed area located along the rear vertical
edge of the oven or coiled above the oven chassis. Do not trap the appliance cable between the oven case back and the rear wall.
For the single ovens and the upper cavity of the double ovens, locate the mounting holes found in the sides of the oven frame. Using a 1/16”
drill, drill four pilot holes for the #6 x 3/4” screws provided in the instruction envelope. Install the screws through the oven frame and into the
cabinet to secure the oven. Do not over-tighten the screws.
Repeat the mounting procedure for the lower cavity if installing a double oven.
WARNINGS:
1. Failure to install the mounting screws may result in movement or tipping of the oven during
use and personal injury.
2. Do not block the oven air exhaust located at the bottom of the oven. Blocking the intake may
cause cabinet damage and poor baking performance.
Case side bottom
both sides
Upper edge of
cavity opening
Figure 11:
Oven gripping points