12
Installation Instructions
7. Connect the ground (green) wire on the cable
using a loop or spade terminal to the ground
connection screw located on the dishwasher
chassis.
8. Re-install the electrical access panel and the toe
kick brackets.
Connecting the Wiring
Permanently Connected Appliance Only:
If the cord is not long enough, or if a hard-wire
installation is needed, follow the steps below to
complete the electrical connection. Otherwise skip
to
Installing the Unit in the Cabinet.
NOtE:
When
doing a hard-wire installation, you must remove the
supplied power cord.
WARNING
•
Before starting this procedure, be sure the
power is disconnected/turned off.
•
Make sure the water supply line, drain line and
outside of the electrical cable do not touch any
exposed terminals of the dishwasher wiring.
1. Remove the toe kick brackets from the front of
the electrical access panel, below the door.
2. Remove the electrical access panel.
3. Disconnect the factory installed power cord from
the terminal block and ground connection screw
inside the access panel. Remove the cord.
4. If a nonmetallic cable is being used, install a UL
listed strain relief bushing on the back of the
dishwasher.
5. Connect the white wire on the cable to the “N”
terminal on the dishwasher terminal block as
shown below.
6. Connect the black wire on the cable to the “L”
terminal on the terminal block.
Neutral (N)
terminal
Junction
box
To house power
supply
Terminal
block
White to
white
(neutral)
Black to
black (line)
Green to
green
(ground)
Line (L)
terminal
Ground
connection
screw (chassis)
Permanent Wiring Connection
Toe kick
bracket
Electrical
access panel
Catch
Terminal block
location
Summary of Contents for RDW24
Page 19: ......