9
Handle Installation (
Model RDW24S
)
Install the door handle according to the handle
installation instructions.
Door Panel Installation (RDW24I Only)
IMPORtANt:
•
The front panel must be installed before
proceeding with installation of the dishwasher.
•
For proper operation and to prevent cabinet or
panel damage, do not allow the panel to obstruct
the exhaust vent on the bottom of the door.
•
If installing a Dacor glass panel, install it and the
handle according to the instructions included with
the glass panel kit, then skip to
Leveling the
Dishwasher
on page 11.
•
For custom door panels, fabricate the panel
according to the included template and attach the
handle before proceeding with panel installation.
Custom Door Panel Installation:
1. Install the Dacor trim kit, PN 106925 (if required),
on the dishwasher according to the instructions
accompanying it.
2. Install the two (2) supplied 3/8” screws on the
back of the door panel in the locations shown in
the diagram, upper right, leaving 1/8” (3.0 mm) of
space between the screw head and the panel.
Installation Instructions
Installation Preparation
WARNING
•
Before working on wiring for any electrical
appliance, be sure the power has been turned
off at the breaker/fuse box. Place a tag at
the disconnect switch indicating that you are
working on the circuit.
•
Moving this appliance requires two people. Do
not attempt to install or lift it alone.
•
To prevent personal injury, wear hand protection
when moving this appliance.
•
Do not allow any material, including the hoses
or electrical wiring to be directly behind the
dishwasher while pushing it into the cutout
opening. Carefully pull the slack out of both
hoses and the wiring from outside the cutout
during push back to prevent pinching. An
electric shock hazard or water damage may
result from pinched wires or hoses. Damage
due to improper installation is not covered under
warranty.
3. Loosen the door height adjustment screws on
each side of the door, near the bottom, and slide
the bottom of the door frame down until it stops.
4. Hang the panel on the front of the door by
hooking the screws installed in step 2 over the
keyholes on the door. Center the panel on the
door.
continued...
Door Panel Screw Locations - 3/8” Screws
CL
3/8” screw,
included,
2 places
15 7/16”
(39.2 cm)
10 7/8”
(26.6 cm)
10 7/8”
(26.6 cm)
Step 3:
Door height
adjustment
screw,
both sides
Step 4:
Hang
on keyhole,
2 places
Summary of Contents for RDW24
Page 19: ......