
18
19
b
efore
y
oU
C
all
for
s
erviCe
Clock Cause
F0
touch pad is stuck in a depressed position (shorted touch pad key) on membrane.
F1
Relay drive circuitry failure. also cooking and self-clean modes shorted touch pad keys only.
F
Oven temperature exceeded the clean runaway temperature (self-clean mode only) or cooking runaway temperature
(cooking modes only).
F3
short circuit in the oven temperature sensor and/or its wiring.
F4
Open circuit in the oven temperature sensor and/or its wiring.
F6
Failure in the eePROM checksum comparison. control failure (microprocessor failure). (Only time of day and timer will
operate.)
F7
Failure of the self-clean automatic door latch circuitry.
F8
Failure of the door latch motor. Occurs when the motor runs for two minutes without the door locking in self-clean mode.
Oven Failure Codes
Problem
Burners ignite but flame is extremely large, distorted
or yellow.
(Rsd Only)
Burner flame goes out at low setting.
(Rsd Only)
ignitors spark continuously after flame ignition.
(Rsd Only)
Problem Solution Guide (Continued)
Possible Cause
Burner ports or burner caps are not positioned properly.
cooktop is being operated on the wrong type of gas.
Regulator is not install, is faulty or is set for the wrong
type of gas.
low gas supply pressure.
air intake holes around knobs are obstructed.
Power supply is not grounded.
Power supply polarity is reversed.
ignitors are wet or dirty.
remedy
Remove and carefully re-install burner rings and
caps.
ensure that the type of cooktop matches the gas
supply (natural gas or l.P. gas).
check installation, replace regulator, or set regulator
for proper gas type.
contact gas company.
Remove obstruction.
Have power supply properly grounded.
Have polarity corrected.
dry or clean ignitors.
P
rodUCT
M
ainTenanCe
i
f
y
oU
n
eed
s
erviCe
do not perform any maintenance other than that instructed in the
CARE AND CLEANING INSTRUCTIONS
section of this manual.
a qualified service technician should perform all other service.
Before you obtain service, please review the
Before You Call
for Service
section on page 16-17. if you have performed the
checks in the
Problem Solution Guide
and the problem has
not yet been remedied, please visit our web site or contact our
customer service team for a listing of dacor
®
authorized service
agents. Prior to requesting service, it is helpful to be familiar with
the warranty terms and conditions listed in the
Product Warranty
section on the inside back cover.
Contact us through our web site at:
www.dacor.com
Dacor Customer service:
tel: (800) 793-0093 (u.s.a. and canada)
Fax: (66) 403-3130
Business Hours:
Monday — Friday 6:00 am to 5:00 pm Pacific time
You may also write us at:
dacor customer service
1440 Bridge gate drive
diamond Bar, ca 91765
At Dacor,
we believe that our quality of service equals that of our
product. Should your experience with our service network or
product be differnt, please contact our Customer Service Team
and share your encounter with us. We will do our utmost to
resolve the situation for you and deliver on our Dacor promise.
Summary of Contents for Millennia MRES Series
Page 22: ...20 Notes ...