Page 2
Refrigerator Handle Kit Installation Instructions
STEP 2 (Model EF36BNFSS only):
Using the T20 Torx driver and the screws removed in step 1, install the six (6) short
mounting studs from the kit in the locations shown.
Handle Mounting
Stud Locations
New mounting
stud from kit
Existing handle
mounting screw
Handle Mounting
Studs
Set Screw Holes
Bottom (Freezer) Handle Installation
STEP 3:
Find the smallest of the three handles in the
kit box.
STEP 4:
Mount the handle to the bottom drawer by
sliding the holes on the back over the handle
mounting studs on the refrigerator. Make sure
the set screw holes on the handle are facing
toward the bottom. You may need to loosen
the set screws using a 3/32” Allen wrench to
allow the handle to slide into place.
STEP 5:
Carefully tighten the set screws into place us-
ing the 3/32” Allen wrench. Be careful not to
scratch the finish.
STEP 6:
Check to make sure the handle is firmly
attached.
