Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
Page 1: ... STEP 1 Using a T20 Torx driver remove the six 6 handle mounting studs from the front of the refrigerator Retain the Torx mounting screws Discard the studs Handle Mounting Stud Locations Existing handle mounting screw keep Existing mounting stud discard Part No 102864 Rev C Parts Included Preference Style Handles 2 Large 1 Small Tools Required 3 32 Allen wrench not supplied T20 Torx driver EF36BNF...
Page 2: ...r Handle Installation STEP 3 Find the smallest of the three handles in the kit box STEP 4 Mount the handle to the bottom drawer by sliding the holes on the back over the handle mounting studs on the refrigerator Make sure the set screw holes on the handle are facing toward the bottom You may need to loosen the set screws using a 3 32 Allen wrench to allow the handle to slide into place STEP 5 Care...
Page 3: ...ish STEP 9 Check to make sure the handle is firmly at tached Top Left Handle Installation STEP 10 Mount the remaining handle to the left door with set screw holes toward the center of the refrigerator Loosen the set screws if neces sary to allow the handle to slide into place STEP 11 Open the left door while holding the handle in place to prevent damage to the other handle during step 12 STEP 12 C...
Page 4: ...Dacor 1440 Bridge Gate Drive Diamond Bar CA 91765 Tel 800 793 0093 FAX 626 403 3130 www Dacor com ...
