NOTE:
The overall height of the appliance can be increased by
1 ⅛” (28.6 mm) by adjusting the feet.
The cut-out dimensions
allow for additional clearance for sliding the appliance into its
recess based on how you chose the final installation to look.
Cabinet Cut-Out and Product Dimensions
l
oCaTIon
r
equIremenTs
Operating Environment
Do not install this appliance where it is hit by direct sunlight or
near a stove, range top, radiator, or similar heat source.
The appliance is set to operate within the room temperature
limits listed below. These temperature limits should not be
exceeded.
ROOM TEMPERATURE REqUIREMENTS
FOR PROPER OPERATION
61°F to 90°F (16°C to 32°C)
Location and Cabinet Layout Requirements
The Dacor wine cooler or beverage center can be recessed in an
opening between cabinets or installed at the end of a cabinet run
using a side panel to enclose it
IMPORTANT:
The installation location should permit the door to open a
minimum of 90°. The maximum angle the door can open is
105°.
The appliance must be located so that the grill on the bottom
is not obstructed.
The electrical outlet must be accessible after installation so
that the user can unplug the appliance.
The floor under the appliance must be flat and level with the
surrounding floor.
◊
◊
◊
◊
◊
◊
p
lannIng
The
I
nsTallaTIon
I
nsTallaTIon
I
nsTruCTIons
u
npaCkIng
The
a
pplIanCe
Protect the floor surface before you un-crate the unit. Put the
unit on cardboard, plywood, or preferably a carpet remnant
(backing up) placed on the floor.
Keep the floor protected when moving the appliance.
◊
◊
If you receive a damaged product, immediately contact
your dealer or builder. Do not install or use a damaged
appliance.
To prevent personal injury, property damage, or damage
to the unit, this appliance should only be unpacked and
set up by two people.
Keep packaging materials away from children. Plastic
sheets and bags can cause suffocation.
Keep the appliance out of the weather. Avoid placing the
appliance in direct sunlight or near a stove, range top,
radiator, or similar heat source.
To protect the unit from possible damage, allow it to stand
in place 1/2 to 1 hour after delivery before turning the
electricity on. Doing so allows the refrigerant and system
lubrication to reach equilibrium.
1.
2.
3.
4.
5.
WARNING
T
ools
r
equIred
for
I
nsTallaTIon
Make sure that you have the necessary tools and materials
available for a proper installation.
Phillips screwdriver set
Level
Crescent wrenches
3 mounting screws (included)
Allen wrench (included)
2 Set screws (included)
Handle (included)
◊
◊
◊
◊
◊
◊
◊