I
nsTallaTIon
I
nsTruCTIons
I
nsTallaTIon
Adjust the appliance height to fit the cut-out using the four
adjustable feet on the underside of the appliance.
Make sure all four feet hit the floor and that the appliance
does not rock.
Place the level on one of the racks inside the appliance.
Check to make sure the appliance is level front to back and
side to side. Re-adjust the feet if necessary.
Slide the appliance into the cut-out.
Attach the appliance to the front of the cut-out as shown
using the four mounting screws included with the unit. The
screws can be installed into the bottom of the counter and/or
into the cabinet in any combination. All four screws must be
used.
Connect the power cord to the electrical outlet. Turn the
appliance on several hours before loading it.
h
andle
I
nsTallaTIon
Put one of the included set
screws on the end of the
included allen wrench.
Insert the set screw into one
end of the handle.
1.
2.
3.
4.
5.
6.
1.
2.
Thread the set screw two turns into the handle.
Repeat steps 1 to 3 for the other end of the handle.
Put both ends of the handle over the handle mounting pins.
Tighten both set screws into place. Do not overtighten.
3.
4.
5.
6.
I
nsTallaTIon
C
heCklIsT
IMPORTANT:
The importance of the proper installation of your
Dacor Built-In appliance cannot be overemphasized. To ensure
a safe and proper installation, the following checklist should be
completed by the installer to ensure that no part of the installation
has been overlooked.
Has the appliance been secured in place?
Are all leveling legs extended down to make contact with the
floor? Is the unit level?
Is the power cord plugged into a properly grounded dedicated
3-prong outlet, which has been installed in accordance with
all applicable electrical codes?
Have any installation/service problems been noted on the
product registration card? Has the registration card been
mailed?
□
□
□
□
NOTE:
Dacor recommends cleaning the appliance according to
the cleaning instructions in use and care manual before use.
