20
Installation Instructions
Hanging the Range Hood
WARNING
Hanging the range hood requires two people
. Do not attempt to lift the hood without assistance.
When hanging the hood, be careful not to scratch or dam-
age the hood.
1. Remove the plastic film from the hood.
There are
hanging slots
in the back of the hood a few
inches from the top. The holding brackets on the wall
engage here and temporarily hold the hood in place.
2. Lift the hood up and catch holding brackets in the
hanging slots
in the back of the hood (see figure
Hanging the Hood).
3. Adjust the hood into its final position.
4. Mark the spot by drawing in a mounting hole in the
back of the hood (see figure Hanging and Mounting
Slots ). This is where a screw will hold the hood to the
wall stud or (concrete) anchor.
5. Mark the top of the hood if the configuration calls for
the hood to be secured at the top.
6. Remove the hood from the wall.
7. Drill the pilot or anchor holes. If using anchors, insert
them into the anchor holes.
8. Reattach the hood to the holding brackets.
9. Adjust the hood into its final position and fasten it into
place:
Insert the fasteners through the mounting slots in the
back and top of the hood and into the studs, mounting
blocks, or anchors.
Holding brackets
Hanging the Hood
Hanging and Mounting Slots
Hanging
slots
in the
back of the hood
Mounting
slots
Summary of Contents for Distinctive DTHP30
Page 30: ...28 Notes ...
Page 31: ......
