Dacor Distinctive DTHP30, Installation Instructions Manual

Page: 14 / 32

12
Rear Exhaust Centerline
Top Exhaust Centerline
These measurements and marks are for centering and
leveling the hood, marking the duct cutouts, and installing
the holding brackets.
The holding brackets temporarily hold the hood while you
mount it permanently into place.
Have a marking tool, tape measure, and level ready.
1. Position the hood in the same orientation as it will be
when installed. (For example, if it is a top vent installa-
tion, set the hood with the vents on top.)
2. Measure the distance from the edge of the hood to the
center of the exhaust port.
3. Transfer that measurement to the wall (for a rear vent),
or overhead (for top vent). Measure the X and Y axis to
find the centerline.
4. Extend the line down 10 inches (25.4 cm).
5. Cut a hole that is 1 inch larger than the duct. Dual
exhaust models require two (2) holes.
Marking the Centerlines
Top Exhaust
Rear Exhaust
DTHP48 Top and Rear
Exhaust Centerline
14 1/8”
(35.88 cm)
Installation Instructions
9 7/8”
(25.08 cm)
CL
CL
CL
48” (121.92 cm)