18
Complete Installation
1. Turn the water supply line valve to the “Open” position.
2. Turn the refrigerator switch to the ON position. See
Power On/
Off Switch
in the use and care manual for instructions. Wait a
few minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the
Care and Cleaning
section in the use and care manual for instructions. Remove
the film and cardboard from the grille and doors or door frame,
depending on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See below.
Water System Preparation
Please read before using the water system.
IMPORTANT:
After connecting the refrigerator to a water source
or replacing the water filter, follow the steps below to make sure
that the water system is properly cleaned.
1. Turn on the ice maker. Lower the wire shutoff arm as shown.
2. Allow 24 hours to produce the first batch of ice.
3. Allow 3 days to completely fill ice container. Fill and discard
three full containers of ice to prepare the water filter for use,
before using the ice.
4. Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.
To get the most efficient use from your new built-in refrigerator,
read your use and care manual. Keep Installation Instructions and
the use and care manual near the refrigerator for easy reference.
Any questions or problems with this installation should be directed
to your Dacor dealer or the Dacor Customer Service Team at
(800) 793-0093 or visit our web site at www.dacor.com.
If you need service, be sure to have the model and serial
numbers when you call. You’ll find these numbers on the serial
number plate, located on the right hand side of the fresh food
compartment.
Installation Instructions
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Summary of Contents for DISCOVERY DYF42BNDI
Page 21: ......
