
1. Characteristics
Th
It
C
N
Bu
ank you for using this product. If there is any problem, you can refer to the operating
instructions, or please contact our technical section.
This product, an indicator displaying micro-voltage signal in digital amplified from various
sensors, is used for fast-measurement of load cell, pressure sensor, torque sensor,
acceleration sensor, etc. that use mainly strain gage. Its characteristics are as follows:
1-1. Fast-conversion mode
employs medium-high A/D conversion unit that can detect 5000 times input signal per
second from the sensor. Besides, analog output signal, by using D/A unit of the same rate,
can be applied to fast analog-digital converter, digital peak hold, sample hold, and interval
peak hold.
1-2. Calibration Mode
alibration mode can be worked either by real-weight(standard weight) or by rated
output(mV/V) from the sensor.
1-3. Various input/output function
ote that it is possible to set RS-232, upper limit & lower limit by using key on the front panel.
Also it is possible to operate contact signal of back panel and RS-232, Zero calibration, Hold
function.
1-4.
Sample Hold, Peak Hold, and Pull Proof function
ilt-in fast hold function makes po/- check of impulse load. Also, interval peak
hold(Pull proof) function can be used for specific use. For option DAC(option-05), it is
possible to hold analog output such as signal when working peak hold. No drop phenomenon
that may change hold value.
1-5.
Comparison function
3