4
Installation
1.
Level unit lengthwise with a carpenter’s plum level.
CAUTION! Do Not completely seal in unit. Access room
must be allowed for motor repair or fabric replacement.
ATTENTION! Ne fixez pas complètement l'unité. Un
espace doit être laissé pour pouvoir réparer le moteur
ou remplacer la toile.
2. Remove shipping brace by removing 2 hex head screws
(Figure 4).
3.
Use supplied 1/8” nex key and a 5/16” wrench to remove
silver shipping brackets attached to slat and screen case.
4. Remove wrapping paper.
CAUTION! Do not cut wrapping paper with knive or any
sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le
ruban adhésif avec un couteau ou un outil tranchant.
Retirez à la main.
5. Install electrical hook up that applies to your unit. Make sure
to review your Electrical Installation Checklists and wiring
diagrams (included) for either 110 volt switch, 220/240 volt
switch, or DRC low voltage control.
6. Test installation by carefully running surface up and down
several times. Be prepared to stop screen.
NOTE:
The picture surface, when rolled down, should have
at least a full wrap and a half around the roller. Do not allow
any part of the roller to become exposed.
Shipping Brace
(Not on 4 1/2" Roller)
Slat
Figure 4
