2
1. Carefully unpack screen and remove outer wrapping
from case.
2. Remove shipping brackets by removing the screws from
the slat bar and wooden board and use supplied 1/8" next
key to remove silver shipping brackets attached to slat.
3. Always handle screen in horizontal position.
There are three methods of mounting to include:
Flush against wall; Suspended from ceiling (use extension brackets); and recessed above ceiling.
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
Save These Instructions
Pre-Installation
Installation
NOTE:
Under no circumstances should unit be completely sealed in recessed installation. Allow access for service. Picture surface is centered
in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to screen slat rod or bottom fabric pocket.
1. Make sure screen is level. Use a carpenter‘s level and plumb level.
CAUTION! Do not cut wrapping paper or tape with knife or any
sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le ruban
adhésif avec un couteau ou un outil tranchant. Retirez à la
main.
2. Install electrical hook-up that applies to your unit. Make sure to
review your Electrical Installation Checklists and Wiring Diagrams
(included) for either 120 Volt Switch, 220/240 Volt Switch, or Low
Voltage Control.
3. Test installation by running screen up and down a few times. Be
prepared to stop screen. Standard Duty Cycle:
1 MIN. ON / 3 MIN. OFF.
NOTE:
Must be installed in accordance with the requirements of
the Local Building Codes, the Canadian Electrical Code (CEC),
CAN/CSA C22.1 and the National Electric Code (NEC), NFPA 70.
Picture
Surface
Picture
Surface
Picture
Surface
Picture
Surface
Ceiling
Mounted
Wall Mounted
Concealed (Allow Room For Access)
Use No. 6
Brackets To
Hang Behind
Beam or
Valance
