background image

TROUBLESHOOTING

 SYMPTOM

 9.   Inconsistent stopping points.

CAUSE

(a)   Limit switch travel plate not mov-

ing.

(b)   Excessive end play in lead screw 

of limit switch assembly.

SOLUTION

(a)     Tighten set screws located on 

nylon gears (drives limit switch).

(b)   Tighten nut between adjusting 

knobs. Tighten lead screw of limit 

switch.

 10.    Screen does not stop going 

up

 or 

down.

(a)   Limit switch assembly paddle 

damaged or is out of place.

(a)   Remove and check limit switch 

assembly. Repair or replace as 

necessary.

7

Printed in U.S.A. 

46490  Rev. 9/09

LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS

Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials 

and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are 

properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after 

shipment from the factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has 

been tampered with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of 

the merchandise.  Returns for service should be made to your Da-Lite dealer.  If it is necessary for the dealer to return 

the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is 

not responsible for damage in shipment.  To protect yourself against damage or loss in transit, insure the product and 

prepay all transportation expenses.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES 

AS TO FITNESS FOR USE AND MERCHANT ABILITY.

  Any implied warranties of fitness for use, or merchantability, 

that may be mandated by statute or rule of law are limited to the one (1) year warranty period.  This warranty gives you 

specific legal rights, and you may also have other rights, which vary from state-to-state.  

NO LIABILITY IS ASSUMED 

FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION OF EQUIPMENT, OR FOR 

INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners 

at PO Box 137, Warsaw, IN  46581-0137,  (574) 267-8101, (800) 622-3737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DA-LITE SHALL NOT BE BOUND BY 

THIS WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH  DA-LITE’S WRITTEN 

INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

Summary of Contents for senIor electrol









Reviews: