Da-Lite Multi vision imager, Instruction Book

Page: 6 / 12

6
Multi Vision Imager Installation
Figure 5
120V Wiring Diagram
Ground-Must Be
Connected To
Building Ground
IMPORTANT NOTE:
The wall switch is REQUIRED to make any limit switch
adjustments, EVEN if a third party control system is used.
Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
UP
STOP
DOWN
Power Input 120VAC / 60Hz
Green (Ground)
Black (Hot)
White (Common)
Power Wire
Data Cable
RJ-45 Jack
RJ-45 Receptacle
RJ-22 Output
RJ-22 Jack
RJ-22
Inputs
RJ-22
Jack
LED
Up
Limit
Tactile
Button
Down
Limit
Tactile
Button
Front Of
Wall
Switch
Back Of
Wall
Switch
Dry Contacts
Up
Down
Common
Bus
5V
BUS
BUS COM 5V
BUS
3-conductor 20-24 gauge wire can be used in place of the
supplied RJ-14 cable to connect the wall switch. Connect the
BUS terminals on the wall switch to the corresponding BUS
terminals on the splitter board.
Figure 6
Low-Voltage Wall Switch
Optional IR And RF
Remote Control
Motor
Blue (Common)
Brown (Hot)
Green
Ground To Case
240VAC 50Hz
240V Wiring Diagram
RJ9
Up
STOP
DOWN
Ground–Must
Be Connected
To Building
Ground
RJ9
Green
Front Back
UP DN GND +5V
3-POSITION
SWITCH
RJ9
Dry Contacts
Splitter
UP +5V COM DN
IMPORTANT NOTE: The wall switch is REQUIRED to make any limit
switch adjustments, EVEN if a third party control system is used.
Therefore, it is advised to wire the switch or provide a 4-conductor
connection that is accessible.
Bus (RP Data)
RQ Data
+5V
Ground
RJ-22 Pin-Outs
(Tab Is Facing Up)
Standard RJ-22 can be used in place of RJ-14 cable
Bus (RP Data)
+12V
RQ Clock
RQ Data
+5V
Ground
Yellow
Green
Red
Black
White
Blue
RJ-45 Pin-Outs
(Tab Is Facing Up)
+12V
Manual 2
Ground
Manual 1
RQ Clock
Bus (RP Data)
RQ Data
+5V
Blue
Green
Yellow
Red
Black
Orange
Purple
Brown
RJ-14 Pin-Outs
(Tab Is Facing Up)
Supplied RJ-14 cable
White
Green
Red
Black
ILT RJ-9 Pin-Outs
(Tab Is Facing Up)
Ground Common
IR or Up
+5V
Data or Down
Red
Green
White
Black