Da-Lite Multi vision imager, Instruction Book

Page: 5 / 12

5
Multi Vision Imager Installation
Electrical Installation
1. Locate and remove junction box cover by
removing two black screws as shown on Figure 4.
Connect electrical power. Insert cable with RJ-22
jack into splitter located inside junction box, route
cable to outside of unit and insert other RJ-22 jack
to the switch.
NOTE: Must be installed in accordance with the
requirements of the Local Building Codes, the
Canadian Electrical Code (CEC), CAN/CSA C22.1 and
the National Code (NEC), NFPA 70.
2. Test installation by carefully running screen up and
down 2-3 times. Be prepared to stop screen.
Standard Duty Cycle: 1 MIN. ON / 3 MIN. OFF.
3.
CAUTION!
Excessive continuous operation may
cause overheating. If motor overheats put switch
in center-off position and allow motor to cool for
30 minutes.
Bracket Distances For Standard Sizes
Screen Size Distance Weight
106"D HDTV 97" 201 Lbs
110"D HDTV 101" 207 Lbs
119"D HDTV 109" 21 Lbs
133"D HDTV 121" 243 Lbs
159"D HDTV 144" 284 Lbs
103"D CS 100" 191 Lbs
115"D CS 111" 208 Lbs
125"D CS 120" 223 Lbs
133"D CS 127" 235 Lbs
138"D CS 131" 241 Lbs
148"D CS 141.5" 258 Lbs
Back Lip Of Frame
Will Wedge Down
Between Wall
Brackets And Wall
Junction
Box
Cover
Black
Screws (2)
Wall
Brackets (2)
Back
Lip Of
Frame
Wall
Bracket
Small “L”
Brackets (2)
Figure 4-1
Screens With A Viewing
Width Of 87" Or Larger
Wall
Bracket Frame
Bracket
Junction
Box
Cover
Black
Screws (2)
Back Lip Of Frame
Will Wedge Down
Between Wall Brackets
And Wall
Small “L”
Brackets (2)
Screens Less The 87"
Viewing Area Width Are Built
With One Frame Bracket
And One Wall Bracket
Figure 4-2
Screens With A Custom
Viewing Width Under 87"
Table 1
Top Frame Length - 20"