7
Step One
Step Five
Step Three
Step Four
Step Two
Do Not Fold Fabric
Onto Black Binding
or Clips
Do Not Fold Fabric
Onto Black Binding
or Clips
Storage
1. The screen surface must be stored in its pouch when not in use
to prevent damage and discoloration.
2. While in storage, avoid extreme temperature conditions. If
surface becomes sticky, see cleaning instructions below.
3. If stored at temperatures far below room temperature, allow the
screen to warm up to room temperature before unfolding. This
will ensure the film is being handled in its most flexible state and
will prevent surface cracks.
Storage And Cleaning
Surface Folding Instructions
Please follow the steps as outlined below when folding the
screen material
for packing:
1. Make sure the surface does not come in contact with a painted,
varnished, plastic, or dyed surface or object. Prolonged contact
with any one of these materials could cause a chemical reaction
and compromise the screen’s physical or optical quality. This can
be accomplished by laying a white clean cotton fabric or paper
(slightly larger than the screen size) on a flat surface prior to
folding the screen.
2. With the surface face up, fold the fabric in half from top to
bottom. Stop just short of the clips so there are no clips stacked
on top of each other (A 7.5' x 10' screen is now 3.75' x 10'). Make
sure the clips are staggered on the side.
NOTE:
Make sure that the screen never comes in contact with
the black binding or clips. Please note that for this to happen, one
must make sure all folds subsequent to the first fold stop short of
black binding material as illustrated below.
3. Place clean tissue paper or white 100% cotton material between
the folds.
4. If the folded area is more than 3 feet wide (which is the case in
the above example), then continue to fold until the folded area is
equal to or smaller than 3 feet wide.
NOTE:
Please remember that all folds subsequent to the first fold
must stop short of the black binding material to keep the viewing
area away from it and the clips as illustrated above.
5. Once the top to bottom folding is completed, fold from left to
right and continue folding until the folded area is small enough to
fit into the vinyl pouch.
NOTE:
The final fold must stop short of the black binding
material to keep the viewing area away from it and the clips as
illustrated.
6. Place the pouch in the poly case on top of the hardware with the
rigid side of the pouch down.
Cleaning
Surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is dampened
with clear water, gently wipe the area in one direction. Do not use a
circular motion. Using a dry 100% cotton cloth, wipe dry after each
cleaning session. To clean a stubborn stain or a sticky surface, use
denatured alcohol (methanol or methyl alcohol) following the same
procedure as for water. For extremely stubborn stains, use
V M & P, Naphtha or Super Naphtha and follow the same procedure
as for water.
