Da-Lite Curved Multi Format Imager, Instruction Book

Page: 6 / 16

6
9. Route the two cable assemblies around motor bracket and
plug the 3 wire male connector into the 3 wire female
connector on the motor bracket. The motor will have a gray
data cable with and RJ-45 connector and RJ-45 coupler
on the end coming out of the head of the motor. Plug the
connector of the cable assembly into the RJ-coupler. Tuck
the RJ-45 coupler underneath motor bracket securely to
prevent entanglement as shown in Figure 8.
10. Remove tape from the black steel wire tension cable located
at the bottom left side assembly. Remove wire tie from the
cable assembly. Run black steel wire tension cable down
around pulley at end and bring back towards the end. You
may have to pull slightly hard and clip the tension cable to
the eyebolt secured in the slat bar as shown in Figure 9. Be
careful not to pinch your fingers in the spring. Repeat this
step for bottom right corner of screen.
Note for 192" Wide Screens Only:
Move black steel wires
away from the front of the screen over and behind the steel
pin located between the end of the aluminum guide track
and the pinch guard.
11. Remove tape from the black steel wire tension cable located
at the top left side assembly. Remove wire tie from the cable
assembly. This cable assembly will have an extra safety wire
ran through the spring. Run black steel wire tension cable
down around pulley at end and bring back towards the end.
You may have to pull slightly hard and clip the tension cable
to the eyebolt secured in the slat bar as shown in Figure 10.
Be careful not to pinch your fingers in the spring. Repeat this
step for top right corner of screen.
Note for 192" Wide Screens Only:
Move black steel wires
away from the front of the screen over and behind the steel
pin located between the end of the aluminum guide track
and the pinch guard.
12. Attach end of safety cable to eyebolt in middle of screen.
Repeat this step for top right corner of screen.
13. Carefully slide the Da-Snap frame inside the main frame as
per Figure 11. First, slide the bottom under the bottom
brackets, then the top, under the top brackets. Lift Da-Snap
frame against the inside top and bottom brackets, align holes
and attach with black knobs.
At this point, preparations are needed to provide electrical power
to unit; see wiring diagrams beginning on page 9.
Curved Multi Format Imager Assembly
Figure 9
Figure 8
Clip Wire Tension
Cable To Eyebolt
Insert Wire Between
Brackets, Lower And
Wrap Around Pulley
Slat Bar
Pinch
Guard
Plug Motor
Power In
Aluminum
Guide Track
Plug Connector
Into Coupler
Data Cable
From Motor Head
Tuck Excess Wire
Underneath
Motor Bracket
Tuck RJ-45 Coupler
Underneath Motor
Bracket