16
PROGRAMMING THE COLLAR
When adding an “Add-On” collar, the collar will need to
be programmed to the transmitter. If your current collar
unit is not responding to the transmitter, it may also
need to be reprogrammed to the transmitter.
1. Select the desired Collar Selector Dial position on
the transmitter.
2. Hold the Transmitter Magnet Indicator (red dot)
directly against the Magnetic Activation Switch (small
bump) on the side of the Collar Unit.
3. The SmartLED light inside the Collar Unit will light
up solid for about 1 second, followed by 6 flashes.
You must keep the Transmitter next to the Collar Unit
during this time.
4. Continue to hold the Transmitter against the Collar
Unit until the SmartLED light stays on solid. The
Collar Unit is now in the
Code Running Mode
(the
SmartLED light will stay lit for approximately 8
seconds while it is in this mode).
5. Remove the Transmitter from the Collar Unit and
press the ‘N’ and ‘C’ buttons simultaneously while it is
in the
Code Running Mode
.
6. When the SmartLED blinks 3 times, the Collar ID
is programmed and the Collar Unit is now ON.
NOTE – Do not move the Transmitter Magnet Indicator
from the Collar Unit Magnetic Activation Switch until
after the SmartLED stops flashing and stays on solid or
the Collar Unit will not go into the
Code Running Mode
.
You must press the ‘N’ and ‘C’ buttons simultaneously
while the SmartLED is lit solid.
Summary of Contents for RedHead RH Pro 1000
Page 1: ...Manufactured by RedHead RH Pro 1000 With SmartLED Owner s Manual ...
Page 4: ...4 ...
Page 23: ...23 ...
