19
These directions are for initial Programming of a new
Launcher, Programming after battery replacement, and
Programming additional Launchers to the Transmitter.
PROGRAMMING RECEIVER/TRANSMITTER
Programming
1. Verify that the Remote Receiver is off.
2. Choose a number (1-16) on the Launcher Selector Knob
of the Transmitter (optional: label the Launcher with the
number for easy recognition).
3. Push and hold the red Power Button on the Remote Re-
ceiver on the RDL Launcher unit.
Do not release the
Power Button.
4. After approximately 6 seconds of holding the Power But-
ton down, the Red LED light will flash 4 times.
5.
While continuing to hold the red Power Button down
,
push
either
the
“BIRD/NICK”
button
or
the
“BEEPER/CONT” button on the Transmitter for approxi-
mately one second.
6. To indicate the unit has been programmed, the LED light
on the Remote Receiver will flash 5 times and the
Beeper/Locator horn will beep 5 times.
7. After programming confirmation, release the Power But-
ton on the Remote Receiver.
NOTE
- Do not release the red Power Button until instructed
to do so or the entire process will have to be repeated. Re-
peat the process from the beginning if the light does not
blink 5 times and beep 5 times at the end of the program-
ming.
WARNING - Do not Program unit while Launcher is
loaded with a Power Load.
