D-MAX DMS-200, User Manual

Page: 11 / 44

3. DIRECTIONS FOR USE
1) DIP SWITCH SETTING
-TERMINALATION RESISTOR (DIP S2/SW1)
~Turn the last camera on the data line as a
switch to turn on/off the terminal resistor on.
Turn the DIP SW of some of the farthest
cameras on in the case of the data lines
distributed to several directions.
* The first default is off.
-ADDRESS/ INITIAL SELECT (DIP S2/SW2)
~Set ADDRESS DIP SW in the status of ADDRESS
(*Reference to next page*)
(.*** The first default is ADDRESS.**)
-Set the communication speed and Protocol
(Demand for the technical inquiry) up in the
state of the INITAIL.
-Select PAL / NTSC system. .(DIP S2/SW 3)
-POWER ON/OFF (DIP S2/SW 4)
Set DIP SW only in the status of Power off.
Then turn on the power after setting DIP SW.
<S2>
<S1>
It shows the status of Power
On/Off. Green LED is On while
power is alive. In the status of
operation, red LED is off.
Set the camera numbers in the state of
ADDR, set communication speed, protocol
in the state of INIT.
-This part is each address of
camera.-
Indoor
Outdoor