D-Link xStack DGS-3120-24PC, Cli Reference Manual

Page: 167 / 1150

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
162
Format
config firmware image {unit <unit_id>} <pathname> boot_up
Parameters
unit - (Optional) Specify which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<pathname> - Specify a firmware file on the device file system.
boot_up - Specify the firmware as the boot up firmware.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure c:/DGS3120_Run_2_00_010.had as the boot up image for unit 2:
DGS-3120-24TC:admin# config firmware image unit 2 c:/DGS3120_Run_2_00_010.had
boot_up
Command: config firmware image unit 2 c:/DGS3120_Run_2_00_010.had boot_up
Success.
DGS-3120-24TC:admin#
12-13 create ipif (RI and EI Mode Only)
Description
This command is used to create an IP interface.
Format
create ipif <ipif_name 12> {<network_address>} <vlan_name 32> {secondary | state [enable
| disable] | proxy_arp [enable | disable] {local [enable | disable]}}
Parameters
ipif - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<network_address> - (Optional) Specify the IPv4 networkaddress (xxx.xxx.xxx/xx). It specifies a
host address and length of network mask.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
secondary - (Optional) Specify the IPv4 secondary interface to be created.
state - (Optional) Specify the state of the IP interface.
enable - Specify that the IP interface state will be enabled.
disable - Specify that the IP interface state will be disabled.
proxy_arp - (Optional) Enable or disable of proxy ARP function. It is for IPv4 function. Default:
Disabled. (RI and EI Mode Only)