D-Link xStack DGS-3120-24PC, Cli Reference Manual

Page: 469 / 1150

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
464
43-1 create address_binding ip_mac
Description
This command is used to create an IMPB entry.
Format
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
ipaddress - Specify the IP address used for the IMPB entry.
<ipaddr> - Enter the IP address used here.
mac_address - Specify the MAC address used for the IMPB entry.
<macaddr> - Enter the MAC address used here.
ports - (Optional) Specify the portlist the entry will apply to. If not ports are specified, the settings
will be applied to all ports.
<portlist> - Enter a list of ports used for this configuration here.
all - Specify that all the ports will be included.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IMPB entry:
DGS-3120-24TC:admin#create address_binding ip_mac ipaddress 10.1.1.1
mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
DGS-3120-24TC:admin#
43-2 config address_binding ip_mac
Description
This command is used to configure the state of IMPB on the Switch for each port.
Format
config address_binding ip_mac ports [<portlist> | all] {arp_inspection [strict | loose |
disable] | ip_inspection [enable | disable] | nd_inspection [enable | disable] | protocol [ipv4 |
ipv6 | all] | allow_zeroip [enable | disable] | forward_dhcppkt [enable | disable] |
stop_learning_threshold <int 0-500>}