DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
207
When a CS becomes a MS, it automatically becomes a member of the first SNMP community (include read/write and read only)
to which the CS belongs. However if a MS has its own IP address, it can belong to SNMP communities to which other switches in
the group, including the CS, do not belong.
The SIM commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
enable sim
disable sim
show sim
{[candidates {<candidate_id 1-32>} | members {<member_id 1-32> } |
group {commander_mac <macaddr>}] | neighbor]}
reconfig
{member_id <value 1-32> | exit}
config sim_group
[add <candidate_id 1-32> {<password>} | delete <member_id 1-32>]
config sim
[{[commander {group_name <groupname 64> | candidate] | dp_interval
<sec 30-90> | hold_time <sec 100-300>}
download sim_ms
[firmware | configuration] <ipaddr> <path_filename> {members <mslist> |
all}
upload sim_ms
[configuration] <ipaddr> <path_filename> <member_id 1-32>
Each command is listed, in detail, in the following sections.
enable sim
Purpose
Used to enable Single IP Management (SIM) on the Switch
Syntax
enable sim
Description
This command will enable SIM globally on the Switch. SIM features
and functions will not function properly unless this function is
enabled.
Parameters None.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To enable SIM on the Switch:
DES-3526:4#enable sim
Command: enable sim
Success.
DES-3526:4#
disable sim
Purpose
Used to disable Single IP Management (SIM) on the Switch
Syntax
disable sim
Description
This command will disable SIM globally on the Switch.
Parameters None.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To disable SIM on the Switch: