30
Using & Configuring the DCS-5300W with a
NAT Router (continued)
Ports that are used by the DCS-5300W
Router Set-Up and Installation
The following steps generally apply to any router that you have on your network.
The D-Link DI-614+ is used as an example to clarify the configuration process.
Configure the initial settings of the DI-614+ by following the steps outlined in the
DI-614+
Quick Installation Guide
.
Access Your Router on Your Web Browser
If you have cable or DSL Internet service, you will most likely have a dynamically
assigned WAN IP Address. ‘Dynamic’ means that your router’s WAN IP address
can change from time to time depending on your ISP. A dynamic WAN IP Address
identifies your router on the public network and allows it to access the Internet.
To find out what your router’s WAN IP Address is, go to the
Status
menu on
your router and locate the WAN information for your router (as shown on the
next page). The WAN IP Address will be listed. This will be the address that
you will need to type in your web browser to view your camera over the Internet.
Be sure to uncheck the
Reset the IP address at next boot
button at the top of
the screen after modifying the IP address. Failure to do so will reset the IP
address when you restart your computer.
These are the port settings
for your camera. If necessary,
these ports can be changed
if they are already in use by
other devices (e.g. in a mul-
tiple camera environment).
Summary of Contents for SECURICAM Network DCS-5300W
Page 141: ...141 Time Zone Table continued ...