5
2. Use the included screws to secure the mounting
plate to the ceiling brackets.
3. Connect the Ethernet cable and power adapter
(optional) to the device.
4. Attach the DBA-2520P to the mounting plate by
placing it onto the plate and rotating clockwise
until the device locks into place.
Locking the DBA-2520P
Attach a Kensington physical security lock to the
Kensington slot on the side of the device to secure
it to an object.
Figure 8: Inserting a Physical Lock
Reboot/Reset the Access Point
If necessary, the DBA-2520P can be manually
rebooted or reset to factory default settings.
Rebooting the device
Press and hold down the reset button between
2 to 5 seconds
then release to reboot the device.
Resetting the device
Press and hold down the reset button between
6 to 15 seconds
then release to reset the device to
its factory default settings.
Press and hold down the reset button for
more than 15 seconds
then release to reset the
device to its factory default settings and force the
device to load an alternate firmware.
Troubleshooting
The DBA-2520P receives its configuration settings
and is managed through the D-Link Nuclias cloud.
If you are experiencing problems connecting
to the D-Link Nuclias cloud, check your Internet
connection. If you still cannot connect to the service,
additional configuration on the device may be
required. Refer to the DBA-2520P User Manual for
detailed information on how to manually configure
the device.
Additional Information
For additional support, please refer to the user
manual, or visit your local D-Link support website.
Warning:
The DBA-2520P is designed to receive PoE
power only from an 802.3at compliant source, or
from a D-Link-approved power adapter. Connecting
an access point to a Power over Ethernet (PoE)
device that is not approved by D-Link can damage
the equipment.
Warning:
This product is to be connected only to
PoE networks without routing to the outside plant.
The equipment power cord must be connected to
a socket-outlet earthling connection.
Avertissement:
Le DBA-2520P est conçu pour
recevoir de l’alimentation PoE uniquement à partir
d’une source compatible 802.3at ou d’un adaptateur
secteur approuvé par D-Link. La connexion d’un
point d’accès à un périphérique Power over Ethernet
(PoE) non approuvé par D-Link peut endommager
l’équipement.
Avertissement:
Ce produit doit être connecté
uniquement aux réseaux PoE sans acheminement
vers l’installation externe. Le cordon d’alimentation
de l’équipement doit être branché sur une prise de
terre avec prise de courant.
