D-Link DGS-1100 Series Switch User Manual
Configuration Restore & Backup
Configuration Restore from HTTP
This window is used to initiate a configuration restore from a local PC using HTTP.
Note
: If the switch is in HTTPS mode, the firmware or configuration cannot be upgraded using
regular HTTP.
To view the following window, click
Tools > Configuration Restore & Backup > Configuration
Restore from HTTP
, as shown below:
Figure 13-7 Configuration Restore from HTTP window
The fields that can be configured are described below:
Parameter
Description
Source File
Enter the source filename and path of the configuration file
located on the local PC. Alternatively click the
Browse
button
to navigate to the location of the configuration file located on
the local PC.
Click the
Restore
button to initiate the configuration restore.
Click
Effective immediately (running-config)
to have the uploaded configuration loaded
immediately.
Click
Take effect after the next boot (startup-config)
to load the configuration after the switch has
been rebooted.
Configuration Restore from TFTP
This window is used to initiate a configuration restore from a TFTP server.
To view the following window, click
Tools > Configuration Restore & Backup > Configuration
Restore from TFTP
, as shown below:
Figure 13-8 Configuration Restore from TFTP window
The fields that can be configured are described below:
Parameter
Description
TFTP Server IP
Enter the TFTP server’s IPv4 address here.
Source File
Enter the source filename and path of the configuration file
located on the TFTP server here.
7
7
5
5
Summary of Contents for EasySmart DGS-1100-16
Page 1: ...1...
