7
D-Link DWR-920V User Manual
Section 2 - Installation
Installation
Initial Setup
Ensure that your DWR-920V Wireless N300 4G LTE Router is disconnected and powered off
before performing the steps below.
1. Verify that your SIM/UICC card is installed and has been activated by your carrier. To install
your SIM/UICC card, follow the diagram next to the slot. Push gently until it locks into place.
Caution:
Always unplug/power down the router before installing or removing the SIM/UICC
card. Never insert or remove the SIM/UICC card while the router is in use.
2. Attach the included antennas to the back of the router, screwing them in clockwise. Arrange
them so that they point upwards.
3. Connect the power adapter to the socket on the back panel of your DWR-920V. Plug the
other end of the power adapter into the wall outlet or power strip. Press the power button
to turn the device on.
4. Press the power button and wait for three seconds to turn on the device.
a. The Power LED will light up green to indicate that power is being supplied to the router
and the router is turned on.
b. After a few moments, the LED indicators will show the current status of the router’s
various functions. For more information, please refer to
LED Indicators
on page 6
This section will guide you through the installation process. Placement of the router is very important. Do not place the router in an enclosed area
such as a closet, cabinet, or in an attic or garage.
2.
3.
1.
SIM
card
SIM
WPS
RESET
