Access Point CLI Commands
15
E
THERNET
S
ETTINGS
Use the commands in this section to view and set values for the Ethernet (wired) interface.
Note:
Before configuring this feature, make sure you are familiar with the names of the interfaces as described in
“Interface Naming Conventions” on page 11
. The interface name you reference in a command determines whether
a setting applies to a wired or wireless interface, the Internal network, or to radio “one” or radio “two”
Table 7: Ethernet Setting Commands
Action
Command
Get Summary View of Internal Interfaces
get bss
Get the DNS Name
get host id
Set the DNS Name
set host id
<host_name>
For example:
set host id vicky-ap
Get Current Settings for the Ethernet (Wired)
Internal Interface
get management
Set the management VLAN ID
set management vlan-id
<1-4096>
View untagged VLAN information
get untagged-vlan
Enable the untagged VLAN
set untagged-vlan status up
Disable the untagged VLAN
set untagged-vlan status down
Set the untagged VLAN ID
set untagged-vlan vlan-id <
1-4096>
View the connection type
get management dhcp-status
Use DHCP as the connection type
set management dhcp-client status up
Use a Static IP as the connection type
set management dhcp-client status down
Set the Static IP address
set management static-ip
<ip_address>
Example:
set management static-ip 10.10.12.221
Set a Subnet Mask
set management static-mask
<netmask>
Example:
set management static-mask 255.255.255.0
Set the Default Gateway
set static-ip-route gateway
<ip_address>
Example:
set static-ip-route gateway 10.10.12.1
View the DNS Nameserver mode
Dynamic—up
Manual—down
get host dns-via-dhcp
Set DNS Nameservers to Use Static IP
Addresses (Dynamic to Manual Mode)
set host dns-via-dhcp down
set host static-dns-1
<ip_address>
set host static-dns-2
<ip_address>
Example:
set host static-dns-1 192.168.23.45
Set DNS Nameservers to Use DHCP IP
Addressing (Manual to Dynamic Mode)
set host dns-via-dhcp up
R
ev
ie
w
C
op
y