136 © 2001-2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access Point Administrator’s Guide
Ethernet Settings
Use the commands in this section to view and set values for the Ethernet (wired) interface.
NOTE: Before configuring this feature, make sure you are familiar with the names of
the interfaces as described in
“Interface Naming Conventions”
on page 132.
The interface name you reference in a command determines whether a setting
applies to a wired or wireless interface, the Internal network, or to radio
“one” or radio “two”.
Enable Remote Logging and Specify
the Log Relay Host for the Kernel
Log
As a prerequisite to remote logging, the Log Relay Host
must be configured first as described in
“Viewing Events
Logs”
on page 92.
Logging command examples:
set log relay-enabled 1
enables remote logging
set log relay-enabled 1
disables remote logging
get log
set log
TAB TAB shows values you can set on the log
Get Transmit / Receive Statistics for
all interfaces
Note: You can also view all transmit
and receive statistics individually.
get interface all ip mac ssid tx-packets tx-
bytes tx-errors rx-packets rx-bytes rx-errors
Get Client Associations
get association detail
Get neighboring access points
get detected-ap detail
Get information about switches that
can discover and manage the AP
get managed-ap
Table 36.
Ethernet Setting Commands
Action
Command
Get Summary View of Internal
Interfaces
get bss
Get the DNS Name
get host id
Set the DNS Name
set host id
<
host_name>
For example:
set host id vicky-ap
Get Current Settings for the
Ethernet (Wired) Internal Interface
get management
Set the management VLAN ID
set management vlan-id
<1-4094>
View untagged VLAN information
get untagged-vlan
Enable the untagged VLAN
set untagged-vlan status up
Disable the untagged VLAN
set untagged-vlan status down
Set the untagged VLAN ID
set untagged-vlan vlan-id
<1-4094>
View the connection type
get management dhcp-status
Table 35.
Status Commands
Action
Command