QUICK INSTALLATION GUIDE | DIS-F100G SERIES
3
Mounting the Switch on a DIN Rail
Before beginning either mounting or removing the DIS-F100G from a DIN rail, please
ensure that the DIN rail is level and that the DIN rail mounting kit is installed correctly on
the DIS-F100G. Use the following instructions to install the DIS-F100G on a DIN rail:
1. With the back of the DIS-F100G facing the DIN rail, lower the top part of the rail
mounting kit onto the DIN rail.
2. Push the DIS-F100G vertically down and rotate the bottom of the DIS-F100G towards
the DIN rail, to attach the Switch to the DIN rail.
Use the following instructions to remove the DIS-F100G from a DIN rail:
1. Push the DIS-F100G vertically down to create enough space at the bottom of the rail
mounting kit to remove the DIS-F100G from the DIN rail.
2. Rotate the DIS-F100G upwards to remove the bottom of the rail mounting kit from the
rail, and lift the DIS-F100G upwards to remove the whole of the Switch from the DIN rail.
Grounding the Switch
To use the DIS-F100G safely, it needs to be grounded. Connect a grounding wire to the
grounding connector on the Switch and use a Phillips head screwdriver to secure the wire.
Attach the other end of the grounding cable to an appropriate grounding source.
Grounding Wire
Before You Begin
Observe the following precautions to help prevent shutdowns, equipment failures, and
personal injury:
•
Install the DIS-F100G in a cool and dry place. Refer to the technical specifications in the
user manual for the acceptable operating temperature and humidity ranges.
•
Leave at least 10 cm of space at the top, rear and bottom of the Switch for ventilation.
•
Visually inspect the power connector and make sure that it is fully secured to the
power cord.
•
Do not stack any devices on top of the Switch.
It is also recommended that power and grounding requirements are investigated before
mounting the Switch.
HARDWARE INSTALLATION
