DGS-3710 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
16
Mounting the Switch in a Standard 19" Rack
Figure 2–3 Installing a DGS-3710 Series Switch in a rack
Fan Modules – Installing and Removing
The Switch is equipt with two removable modules. On the one side we find a fan module and on the other side we find
a dust filter module. Fan and dust filter modules have handles for users to replace these modules easily. To install any
of the two modules, simply slide it into the available slot at the front of the Switch until it reaches the back. Carefully
push the module into the slot to secure it to the Switch. The module should fit snugly into the corresponding receptors.
Figure 2–4 Installing a DGS-3710 Series Switch Fan Module
After the modules are secured, tighten the screws at the adjacent ends of the modules into the available screw holes
on the Switch. The Switch is now ready for use.
CAUTION:
The handles on the fan modules should only be used to replace the modules in the event of a
hardware failure. Do not use the power module handle to lift the Switch.