4 Configuration
D-Link Smart Managed Switch User Manual
3
3
3
3
Figure 4.41 – L2 Features > Link Aggregation
The fields that can be configured for
Link Aggregation
are described below:
Item
Description
Link Aggregation Global Settings
Link Aggregation
Specify to enable or disable the Link Aggregation function.
Channel Group Information
ID
Use the drop-down menu to select a link aggregation group.
Port
Select the ports to assign to the aggregation group.
Table 4.24
Click
Apply
to make the configurations take effect.
Click
Delete
to remove the Link Aggregation group.
NOTE:
Maximum number of ports in a Link
Aggregation group is 4. DGS-1100-05 only
supports 1 Link Aggregation group, and DGS-
1100-08 supports up to 2 Link Aggregation
groups.
NOTE:
Each combined port must be connected to
devices within the same VLAN group.
L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Settings
With Internet Group Management Protocol (IGMP) snooping, the Smart Managed Switch can make
intelligent multicast forwarding decisions by examining the contents of each frame’s Layer 2 MAC header.
By default, IGMP is disabled. If enabled, the Smart Managed Switch can recognize IGMP queries and
reports sent between network stations or devices and an IGMP host. With IGMP snooping enabled, the
Smart Managed Switch will forward multicast traffic only to the connections that requested it.
Figure 4.42 – L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Settings
The fields that can be configured for are described below:
