4 Configuration
D-Link Smart Managed Switch User Manual
16
System Contact
Specify the system contact of the Switch.
Web Session Timeout
(60-36000)
The Web Session Timeout controls the idle time-out period for
security purposes, when there is no activity in the web
interface within the specified time-out period. If the current
session times out (expires), the user is required to log into the
web management interface again. Selective range is from
60
to
36000
seconds, and the default setting is
180
seconds.
Table 4.1
Click
Apply
to make the configurations take effect.
System > System Information Settings > IPv4 Interface
The IPv4 Interface allows the user to configure the IP address and the basic system information of the
Switch.
Figure 4.14 – System > System Information Settings > IPv4 Interface
The fields that can be configured for
IP Settings
are described below:
Item
Description
IP Settings
There are two ways for the Switch to obtain an IP address:
Static and DHCP (Dynamic Host Configuration Protocol).
When using static mode, the
IP Address
,
Mask, Gateway
and
DHCP Retry Time
can be manually configured. When using
DHCP mode, the Switch will first look for a DHCP server to
provide it with an IP address (including network mask and
default gateway) before using the default or previously entered
settings.
IP Address
Specify the IPv4 address. By default, the IP address is
10.90.90.90
Mask
Specify the subnet mask of IP address. By default, the subnet
mask is
255.0.0.0
Gateway
Specify the gateway of IP address. By default, the gateway is
0.0.0.0
DHCP Retry Time (5-
120)
Specify the number of attempts to assign an IP address
through a DHCP server. Selective range is from
5
to
120
times,
and the default setting is
7
times.
Table 4.2
Click
Apply
to make the configurations take effect.
System > Port configuration > Port Settings
In the Port Setting page, the status of all ports can be monitored and configured.
