DFE-650 Series Fast Ethernet PC Card User's Guide
20
Software Installation
following the last of the included drivers, there are some additional
options. Highlight
USER SPECIFIED 32 BIT DRIVER
Then key
<F10>
to continue.
"Insert The Driver Disk" Dialog Box
Insert the D-Link DFE-650 Series Fast Ethernet PC Card Driver
diskette into a diskette drive of the notebook PC. Type this path-
name into the textbox (here assuming the diskette drive to be Drive
A):
A:\NETWARE\32BITLAN\
Then key
<Enter>
to continue. The dialog box closes, and the
DFE-650 driver name appears highlighted in the "32-Bit Network
Board Drivers" screen. Key
<F10>
to continue.
"Settings for D-Link DFE-650 Fast Ethernet PC Card
Driver"
This screen provides control of four settings. The
Connection
Type
setting is an aggregate setting which includes Line Speed
(10Mbps or 100Mbps) and Duplex (Half Duplex or Full Duplex). It
is recommended that you deselect all line speed and duplex
settings, by celecting “ none” as
Connection Type
.
WARNING:
Whenever any value is shown for either Line Speed
or Duplex (i.e., the Connection Type setting is
different from “none”), then the entire autonegotiation
function of the DFE-650 will be disabled (turned off).
It is ordinarily best not to change either of the next two settings,
Driver Retries
or
Frame Type
, from their default
values. The first of these two parameters affects the error-
correction processing of defective data packets. The default value
