xStack
®
DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Hardware Installation Guide
The Switch's MAC address can also be found from the Web management program on the
Switch Information (Basic
Settings)
window on the
Configuration
menu.
The IP addre ss for the Switch must be set before it can be mana ged with the Web -based manager. The Switch IP
address can be automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the
Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
Starting at the command line prompt, enter the commands
config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy
Where the x's rep resent the IP addre ss to be assig ned to the IP interface n amed System and the y's repre sent the
corresponding subnet mask.
Alternatively, you can en ter
config ipif System ipaddress xxx.xxx.xxx.xxx/z.
Where the x's rep resent the IP
address to be assigned to the IP interface named System and the z represents the corresponding number of subnets
in CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask, and then be used to
connect a management station to the Switch's Telnet or Web-based management agent.
DES-3528:admin#config ipif System ipaddress 10.90.90.90/255.0.0.0
Command: config ipif System ipaddress 10.90.90.90/8
Success.
DES-3528:admin#
Figure 4- 5. Assigning the Switch an IP Address
In the above example, the Switch was assigned an I P address of 10.90.90.9 0 with a su bnet mask of 255 .0.0.0. (the
CIDR form was used to set the address (10.90.9 0.90/8). The system message
Success
indicates that the command
was executed successfully. The Switch can now be configured and managed via Telnet and the CLI or via the Web-
based management.
22
Summary of Contents for DES-3528 - xStack Switch - Stackable
Page 66: ......
