xStack
®
DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Hardware Installation Guide
2
routers, switches and other networking devices. The dual speed ports use standard twisted-pair cabling and are ideal
for segmenting networks into small, connected sub networks for superior performance. Each 10/100 port can support
up to 200 Mbps of throughput in full-duplex mode.
In addition, the Switch has 2 SFP combo ports. These two-gigabit combo ports are ideal for connecting to a server or
network backbone. This stackable Switch enables the network to use some of the mo st demanding multimedia and
imaging a pplications concurrently with other user applications without creat ing bottlene cks. The b uilt-in co nsole
interface can be used to configure the Switch's settings for prio rity queuing, VLANs, and port trun k group s, port
monitoring, and port speed.
Features
•
IEEE 802.3 10BASE-T compliant
•
IEEE 802.3u 100BASE-TX compliant
•
IEEE 802.1p Priority Queues
•
IEEE 802.3x flow control in full duplex mode
•
IEEE 802.3ad Link Aggregation Control Protocol
support.
•
IEEE 802.1X Port-based and MAC-based Access
Control
•
IEEE 802.1Q VLAN
•
IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid
Spanning Tree and IEEE 802.1s Multiple Spanning
Tree support
•
Access Control List (ACL) support
•
Single IP Management support
•
Access Authentication Control utilizing TACACS,
XTACACS and
•
Dual Image Firmware
•
Simple Network Time Protocol support
•
MAC Notification support
•
Asymmetric VLAN support
•
System and Port Utilization support
•
System Log Support
•
Support port-based enable and disable
•
Address table: Supports up to 16K MAC addresses
per device
•
Supports a packet buffer of up to 1 Mbyte
•
Supports Port-based VLAN Groups
•
Port Trunking with flexible load distribution and fail-
over function
•
IGMP Snooping support
•
SNMP support
•
Secure Sockets Layer (SSL) and Secure Shell
(SSH) support
•
Port Mirroring support
•
MIB support for:
•
RFC1213 MIB II
•
RFC14 93 Bridge
•
RFC1907 SNMPv2 MIB
•
RFC1757, 2819 RMON
•
RFC20 21 RMONv2
•
RFC1643, 2358, 2665 Ether-like MIB
•
RFC2233, 2863 Interface MIB
•
Private MIB
•
RFC2674 for 802.1p
•
RFC2618 RADIUS Authentication Client
•
RFC2620 RADIUS Accounting Client
•
RFC2925 Ping & Traceroute
•
IEEE 802.1X MIB
•
RS-232 DCE console port for Switch management
•
Provides parallel LED display for port status such as
link/act, speed, etc.
•
High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881 packets/sec on
each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port.
•
Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to simultaneously
transmit and receive data. It only works with connections to full-duplex-capable end stations and switches. Connections to a
hub must take place at half-duplex
•
Support broadcast storm filteringF
•
Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
•
Supports by-port Egress/Ingress rate control.
•
Supports IP-MAC Port Binding.
•
Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
•
Supports STP Loopback Detection
•
Safeguard Engine Support
Summary of Contents for DES-3528 - xStack Switch - Stackable
Page 66: ......
