D-Link DES-3526 - Switch - Stackable, Manual

Page: 45 / 258

DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
32
To configure switch ports:
1. Choose the port or sequential range of ports using the From…To… port pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
Parameter Description
State <Enabled> Toggle the State field to either enable or disable a given port or group of ports.
Speed/Duplex <Auto> Toggle the Speed/Duplex field to either select the speed and duplex/half-
duplex state of the port.
Auto denotes auto-negotiation between 10 and 100
Mbps devices, in full- or half-duplex. The Auto setting allows the port to
automatically determine the fastest settings the device the port is connected to
can handle, and then to use those settings. The other options are
Auto ,
10M/Half , 10M/Full, 100M/Half and 100M/Full . There is no automatic
adjustment of port settings with any option other than Auto.
Flow Control Displays the flow control scheme used for the various port configurations.
Ports configured for full-duplex use 802.3x flow control, half-duplex ports use
backpressure flow control, and
Auto ports use an automatic selection of the
two. The default is Disabled .
Learn Enable or disable MAC address learning for the selected ports. When Enabled ,
destination and source MAC addresses are automatically listed in the
forwarding table. When learning is
Disabled , MAC addresses must be
manually entered into the forwarding table. This is sometimes done for
reasons of security or efficiency. See the section on Forwarding/Filtering for
information on entering MAC addresses into the forwarding table. The default
setting is
Disabled .
Click Apply to implement the new settings on the Switch.
Port Description
The DES-3526 supports a port description feature where the user may name various ports on the
Switch. To assign names to various ports, click the
Port Description on the Configuration menu: