5
5
1
1
Authentication Port:
sets primary port for security monitoring.
Default is 1812.
Key:
Masked password matching the Radius Server Key.
Confirm Key:
Enter the Key a second time for confirmation.
TxPeriod:
Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the client before
retransmitting the request. Default is 24 seconds.
ReAuthEnabled:
This
Enables
or
Disables
the periodic
ReAuthentication control. When the 802.1X function is
Enabled
, the
ReAuthEnabled function is by default also
Enabled
.
QuietPeriod:
Sets the number of seconds that the switch remains in
the quiet state following a failed authentication exchange with the
client.
Default is 80 seconds
SuppTimeout:
Sets the switch-to-client retransmission time for the
EAP-request frame. Default is 12 seconds.
ServerTimeout:
Sets the amount of time the switch waits for a
response from the client before resending the response to the
authentication server. Default is 16 seconds.
MaxReq:
This parameter specifies the maximum number of times
that the switch retransmits an EAP Request packet to the client before
it times out the authentication session. Default is 5 times.
ReAuthPeriod:
This command affects the behavior of the switch only
if periodic re-authentication is enabled. Default is 3600.
To establish 802.1X port-specific assignments, select the
From
and
To
Ports
and select
Enable
.
Summary of Contents for DES-1252 - Web Smart Switch
Page 4: ...i ii ii i Monitoring Statistics 53 ...
Page 5: ......
Page 60: ...5 55 5 Figure 435 Monitoring Port Statistics ...
