D-Link DES-1018MP, Quick Installation Manual

Page: 3 / 64

3
E
N
G
LI
S
H
Link/Act/Speed
10/100 Mbps Ports
(Ports 1 to 16)
Green
Solid
light
When there
is a secure
connection (or
link) to 10/100
Mbps Ethernet
device at any
of the ports.
Blinking
When there is
reception or
transmission of
data occurring
at 10/100
Mbps.
Off Off No link
PoE
(Ports1 to 16)
Green
Solid
light
The port is
successfully
connected
to a PoE
device and
is powering
the device
properly.
Red
Solid
light
The PoE port
has failed,
possibly due
to:
1. PoE total
power budget
shortage
2. Over
current:
Exceeds the
power current
of powered
device's
classification.
3. Short circuit:
An intentional
short circuit
has been
performed on
a powered
device.
Off Off
No connection
to a PoE
device
Installation and Connection
This section describes how to install a
DES-1018MP in a standard 19-inch equipment
rack and how to connect cables and power to
the device.
Before You Begin
Observe the following precautions to help
prevent shutdowns, equipment failures, and
injuries:
• Install the DES-1018MP in a cool and dry
place. Refer to the Technical Specifications
for the acceptable operating temperature
and humidity ranges.
• Install the Switch in a site free from strong
electromagnetic source, vibration, dust,
and direct sunlight.
• Leave at least 10 cm of space at the left and
right-hand side of the Switch for ventilation.
• Visually inspect the power jack and make
sure that it is fully secured to the power
cord.
• Do not stack any device on top of the Switch.
Step 1 – Unpacking
Open the shipping carton and carefully unpack
its contents. Please consult the following packing
list to make sure that all items are present and
undamaged. If any item is missing or damaged,
please contact your local D-Link reseller for a
replacement.
Package Contents
DES-1018MP Switch 1
Power Cord 1
Power Cord Retainer 1
Rack Mount Kit and Rubber Feet 1
Quick Installation Guide 1
Step 2 – Installation
You can mount the DES-1018MP into a
standard 19-inch equipment rack. To install
the DES-1018MP into a rack:
1. Attach the mounting brackets to each side
of the chassis as shown in Figure 3 and
secure them with the screws provided.
Figure 3. Mounting Brackets