![background image](http://html.mh-extra.com/html/d-link/dcs-5230l/dcs-5230l_user-manual_77649032.webp)
27
D-Link DCS-5230L User Manual
Section 4 - Configuration
Motion Detection
Click this box to enable the PIR sensor.
Click this box to enable video motion detection.
This setting adjusts how sensitive the camera will be to motion,
where 100% will be the most sensitive setting and 0% will be the
least sensitive setting.
This will allow you to draw motion detection zones when clicking
and dragging, or erase motion detection zones when clicking and
dragging depending on which option you have selected.
Clicking this button will clear all motion detection zones.
After making any changes, click the
Save Settings
button to save your changes, or click the
Don’t Save Settings
button
to discard your changes.
Note:
If the camera is set to SXGA mode in Audio and Video, Motion Detection is disabled.
This option allows you to set up Motion Detection on your IP camera. In
order to use motion detection you must first check the
Enable Video Motion
checkbox. You can then click on the video window and draw motion detection
zones by clicking and dragging your mouse. Red areas indicate areas that will
be monitored for motion. The camera also has a PIR sensor which is used to
detect motion using a special infrared sensor. PIR is good at detecting motion
from live subjects such as people and animals.
Enable PIR:
Enable Video Motion:
Sensitivity:
Draw Motion Area:
Erase Motion Area:
The motion notification will continue to blink as long as motion is detected. If no additional
motion is detected, it will return to its original state after eight seconds.
The red grid on the right indicates an area that has been selected for motion detection.
When motion is detected, the LIVE VIDEO page will display a blinking orange motion video
icon like the one below.
No Motion Motion
Summary of Contents for DCS-5230L
Page 1: ......