Before You Begin
It’s best to use a computer (with an Ethernet adapter) connected to a switch to configure the DAP-3520.
The default IP address for the DAP-3520 is 192.168.0.50 with a subnet mask of 255.255.255.0 on the
wired Ethernet side. You will need to assign your computer a static IP address within the same range
as the DAP-3520’s IP address for the purpose of configuring the DAP-3520. If you need assistance
assigning a static IP address to your network adapter, please refer to the manual on the CD-ROM.
Important Information
This product should ONLY be installed by an experienced installer who is familliar with local building
and safety codes and where ever applicable, is licensed by the appropriate authorities. Failure to
do so may void the D-Link product warranty and may expose the end user or the service provider
to legal and financial liabilities. D-Link and its resellers or distributors are not liable for injury,
damage, or violation of regulations associated with the installation of outdoor units or antennas.
A safety grounding system is necessary to protect your outdoor installation from lightning
strikes and the build-up of static electricity. The grounding system must comply with the National
Electrical Code and safety standards that apply in your country. Always check with a qualified
electrician if you are in doubt as to whether your outdoor installation is properly grounded.
Note:
DAP-3520 is certified to IP65 which means the device is protected from dust and low pressure
jets of water from all directions - limited ingress permitted. It is recommended to place this
device under a roof.
