11
D-Link DAP-1900 User Manual
Section 3 - Configuration
WPS-PBC Configuration
Step 1 - Initiate WPS Mode
While the Status LED is blinking orange, push the WPS button on the source
wireless router or AP, and then push the WPS button on the DAP-1900. The Status
LED will start to flash white. Please allow up to two minutes for the process
to finish. The LED will turn solid white when the DAP-1900 has connected
successfully to the source wireless router or access point.
Step 2 - Connecting Devices to the DAP-1900
The DAP-1900 is now ready to share the extended Wi-Fi network with your PCs
and mobile devices. You may use the WPS method to connect devices to the
extended network created by the DAP-1900 using the following network names
(SSID). The password will be the same as the wireless network you are extending.
• (Your router’s SSID)-EXT
The Smart Connect feature will present a single wireless network. When
connecting clients to the extended network, they will be automatically added to
the best band, either 2.4 GHz or 5 GHz. To disable the Smart Connect feature and
individually configure 2.4 GHz and 5 GHz SSIDs, refer to “Extender Settings” on
page 26.
Wireless Protected Setup (WPS) makes connecting your DAP-1900 easy. To use WPS, first make sure the source router or access
point features a physical or virtual WPS button.